1. Faucet Installation
For One-Hole Sinks
Use the appropriate gasket (provided).
For Three-Hole Sinks
Apply plumbers putty or other sealant to the bottom edges of the
undercover according to the manufacturer’s instructions.
Place the undercover over the sink holes.
Align and press the undercover in place.
Remove any excess putty.
Place the escutcheon over the undercover.
For All Sinks
Partially thread two screws into the threaded ring until the
screws barely protrude from the backside of the threaded ring.
Fit the faucet through the hole in the sink. Position the faucet so
the handle faces in the desired position. The recommended
handle position is to the user’s right.
Turn the ring so the screws are to the front and back.
Use a Phillips screwdriver to tighten the screws securely and
evenly.
Escutcheon For
Three-Hole Sinks
Gasket For One-Hole Sinks
Escutcheon for One-Hole Sinks
Sink
Fiber Washer
Metal Washer
Screw
Ring
Gasket
Undercover
Faucet
Kohler Co. 3 1013943-2-D
To Next Page
Loading...
Need help?
General
