25
UM KD 225-350-420 - KD15-440 _ cod. ED0053029960 - 1° ed_rev. 00
.
Since the oil must be emptied out while the engine
is still hot (approx. 80°C), particular care should
be taken in order to avoid burns. In any case
make sure that oil does not come into contact
with your skin because of the health hazards
involved.
. Fuel vapours are highly toxic, so ll up only in the
open air or in well ventilated environments.
. During operations which involve access to moving
parts of the engine and/or removal of the rotary
guards, disconnect and insulate the positive cable
of the battery so as to prevent accidental short
circuits and activation of the starter motor.
. Check the belt tension only when the engine is
turned off.
. To start the engine follow the specic instructions
provided in the engine and/or machine operating
manual. Do not use auxiliary starting devices not
originally installed on the machine (e.g. Startpilot
systems which utilise ether etc.)
. Before carrying out any work on the engine, turn it
off and allow it to cool down. Do not perform any
operation while the engine is running.
. Check that the discharged oil, the oil lter and the
oil contained in the oil lter are disposed of in
such a way as not to harm the environment.
. Close the fuel tank ller cap carefully after each
fílling operation. Do not ll the tank right up to
the top, but leave sufcient space to allow for any
expansion of the fuel.
. Do not smoke or use naked ames while lling.
. Take care when removing the oil lter as it may be
hot.
. The operations of checking, lling up and replacing
the cooling liquid must be carried out with the
engine turned off and cold. Take particular care
if liquids containing nitrites are mixed with others
not containing these compounds as this may give
rise to the formation of nitrosamines which are a
health hazard. The cooling liquid is polluting, so
dispose of in a manner that does not damage the
environment.
. In order to move the engine simultaneously use
the eyebolts tted for this purpose by .
These lifting points are however not suitable
for the entire machine, so in this case use the
eyebolts tted by the manufacturer.
To Next Page
Loading...
Need help?
General
