Kohler KG40

166 TP-6694 6/22
Description
Controller
Display
Message
Write
Access
Display
SiteTech
GenSet
Mode
Always
Running
Stopped
Range
Setting
Default
Selection
Time
Delay
Range
(sec.)
Default
Time
Delay
(sec.)
Programmer-
Defined
Settings
Charger Voltage Bulk
(V)
S
A
13–15
(12 V)§
26–30
(24 V)§
14.25
(12 V)
28.5
(24 V)
Adjustable with
Charger
Custom Profile
enabled.
Charger Voltage
Equalize (V)
Note:
Equalize is only
available with
FLA/VRLA topology
selected.
S
A
14–16
(12 V)
28–32
(24 V)
Adjustable with
Charger
Custom Profile
enabled.
Charger Voltage Float
(V)
S
A
13–14
(12 V)§
26–28
(24 V)§
13.25
(12 V)
26.5
(24 V)
Adjustable with
Charger
Custom Profile
enabled.
Current transformer
ratio ‡
S
S
1-
1200
ECM power
S
S
0-1
0
0-600
300
Engine cooldown delay
S
A
10-30
15
Engine (cyclic) crank on
S
A
1-60
15
Engine (cyclic) crank
pause
S
A
0-300
0
Engine ECM start delay
S
A
0-60
60
Engine idle duration
S
A
Engine no. of (cyclic)
crank cycles
S
S
1-6
3
Engine restart delay
S
A
1-10
10
Engine start aid delay
S
A
0-10
0
Engine start delay
S
A
0-300
0
Equalize Current Limit
(A)
Note:
Equalize is only
available with
FLA/VRLA topology
selected.
S
A
1–5
Adjustable with
Charger
Custom Profile
enabled.
Forced Charge Cycle
Reset
S
A
Active
Inactive
Inactive
Output Enable
Reduced Out
S
A
Fixed
Active
Voltage regulator gain
S
R
1-255
128
Voltage regulator
stability adjust
S
R
1-255
128
Voltage regulator, volts
per Hertz slope
S
R
1-10
5
Voltage regulator, volts
per Hertz cutin
frequency
S
R
42-62
57.5
* Some functions require optional input sensors or are engine ECM dependent on some generator set models.
† ECM inputs are engine manufacturer dependent.
‡ Changeable only by resetting the controller with a personality profile (SiteTech 1.4 or higher).
§ Denotes the default parameter range. Typically, ranges for the NiCad battery topology are slightly wider. For more details, refer to the
battery charger operation manual.
ST- Short Term, LT- Long Term