TP-6461 1/08116 Appendix
View Source Setup
D ABC/BAC Rotation (3-phase only)
D System Voltage, Normal/Emergency
D Frequency (Hz), Source N and E
D Normal Under Voltage PU% and DO%
d Normal Over Voltage PU% and DO%
d Debounce Time, Seconds
D Normal Under Frequency PU% and DO%
d Debounce Time
D Normal Voltage Unbalance Enable/Disable
d Normal Voltage Unbalance PU% and DO%
D Emergency Under Voltage PU% and DO%
d Emergency Over Voltage PU% and DO%
d Debounce Time
D Emergency Under Frequency PU% and DO%
d Emergency Over Frequency PU% and DO%
d Debounce Time
D Emergency Voltage Unbalance Enable/Disable
d Emergency Voltage Unbalance PU% and DO%
View Time Delays
D Source N and E
d Engine Start (gen set only)
d Engine Cooldown
D Load Disconnect N>E (E>N)
D Xfr Off > N (Off > E) (programmed--transition only)
D Xfr N>E (E>N)
D Loads to Control (1--9)
D Load Add N>E (E>N)
D Load Disc E>N (N>E)
D In Phase Xfr Fail Time Delay and Enabled/Disabled
D Fail to Acquire Standby (Preferred)
View Inputs/Outputs
D Main Board I/O
d Input Function Descriptions (2)
d Output Function Descriptions (2)
D Auxiliary Inputs/ Outputs
d Aux I/O Module
d Module Type and Address
d Module Status
d Input Function Descriptions
d Output Function Descriptions
View Common Alarms
D Alarm Group (1 and 2)
D Alarm Description
D Audible (Yes or No)
D Common (Yes or No)
View Communications Setup
D Modbus Server TCP Enabled/Disabled
D Modbus Server Port 1 and 2
Enable/Disabled
D Modbus Address Port 1 and 2
D Baud Rate Port 1 and 2
9600/19200/57600
D Modbus TCP Unit ID
D IP Address
D Subnet Mask
D MAC Address
View Control Parameters
D Code Version
D ATS Serial Number
D Controller Serial Number
D Contactor Serial Number
D Site Designation
D Load Description
D Branch Description
D Location
Setup Screens
Set Time/Date
D Set Time
D Set Date
D Set Automatic Daylight Saving Time
Set Exerciser
D Exerciser Event Enable/Disable
D Exerciser Event Loaded/Unloaded
D Exerciser Event Interval
D Exerciser Event Repeat Rate
D Exerciser Event Duration
D Exerciser Event Start Date
D Exerciser Event Start time
Set Time Delay
D Source N(E)
D Engine Start
d External Battery? Y or N
D Engine Cooldown
D In Phase Transfer Fail
D Load Disconnect N>E (E>N)
D Transfer N>E (E>N)
D Transfer Off>E (Off>N)(programmed-transition only)
D Load Add E>N (N>E)
D Loads to Add (1--9)
D Fail to Acquire Preferred Source
D Fail to Acquire Standby Source
To Next Page
Loading...
