.
- FILLER -
l
CARTRIDGE
TYPE
RUBBER
SEAL
\
MOUNTING GASKET
(DON’T REVERSE
POSITION TO
BLOCK OIL HOLES)
FIGURE 2-2 -- OIL FILLER - BREATHER
FIGURE 2-3 -- OPTIONAL OIL FILTER
OIL FILTER - OPTION
.
If your engine is equipped with the
0p tional oil
filter,
change the filter cartridge after each 200
hours of operation. This should be done
at the same time
change. Wrap rags
the oil 1s drained during every fourth oil
around the base and
use pan to c atch a ny oil trapped in the cartridge. Twist car-
tridge off by hand- turn in counterclockwise direction to remove.
engine oil isreplen,ished and engine is again placed in operation,
l&d tighten new cartridge--‘after
leakage--retighten element as needed to stop leaks.
check area around filter for signs of
Doa? use substitute cartridge elements for replace-
ment-use only genuine Kohler parts.
If the engine does not have a filter but is operating in high dust, dirt areas, the oil filter feature
can be quickly added.
Simply remove the two plugs from the filter mounting, position a new gasket on
the pad (make sure holes in gasket match oil holes) and secure the filter assembly with 4 capscrews.
*
3
22
l
. .
.
To Next Page
Loading...
