10
1017598-2-A
Kohler Co.
3. START-UP:
1. Turn on water.
2. Check for leaks.
3. Turn on power.
4. Open Rite-Temp valve. Turn Rite-Temp valve stem clockwise
to open, counterclockwise to close. When mixer is opened,
initial flow will be through upper showerhead.
5. See Fig. #21 . The keypad controls tower assembly outlets
and flow patterns. Turn on valve. Make desired adjustments.
Fig. #21
6. See Fig. #22 . Check body sprays for smooth operation.
7. Push body button to enable pulse and sweep functions.
8. The left button below this provides stop/start pulse action and
the lowermost buttons adjust rate up and down.
9. The right button below the central button provides start/stop
sweep action and the lowermost buttons adjust speed up and
down. If body sprays are sweeping when stop is pressed,
sweep action will continue until body sprays re-center.
10. To adjust spray pattern individually on body sprays, adjust the
body spray outer ring clockwise for concentrated (hard)
spray, and counterclockwise for full (soft) spray.
11. The height angle of the body spray may be adjusted by
swiveling the entire exposed body spray assembly upward or
downward.
12. See the Owner’s Manual, if necessary, for additional
operating instructions.
Fig. #22
Body Spray
Button
Body
Sprays
To Next Page
Loading...
