Kohler MasterShower K-74 - Installation; Transformer Kit Installation; Mounting Box and Valve Assembly

4
1017598-2-A
Kohler Co.
2. INSTALLATION
Familiarize yourself with the MasterShower tower
assemblies before proceeding. See Fig. #5 .
Fig. #5
End Cap Assembly
Sheetflow Assembly
Body Spray
Rite-Temp
Handle
Key Pad
Three-Way
Showerhead
Tower Assembly
Manifold Assembly
TB1 Plug
Circuit Board
Strain Relief
Hose From Manifold
Strainer
Screw
Cover
Screw
Transformer
Enclosure
A. TRANSFORMER KIT:
1. See Fig. #6 . Mount transformer kit (not supplied with
K-74-JA) at roughed-in location. Allow clearance for knockout
for electrical service. Remove cover plate. Secure with wood
screws through two mounting holes. Route SJO cord
between transformer enclosure and mounting box rough
opening. Re-install cover plate.
Do not make electrical connection to transformer yet,
unless power to transformer can be left off until after
MasterShower tower installation is complete.
Fig. #6
Screw
Cover
Enclosure
Transformer
B. MOUNTING BOX AND VALVE ASSEMBLY:
1. Install finish wall before proceeding with MasterShower tower
installation.
2. Turn off water to supply risers. Uncap risers, if applicable.
Confirm proper riser height.