Need help?Do you have a question about the Kohler Purist K-T97328-4-BN and is the answer not in the manual?
General| Brand | Kohler |
|---|---|
| Model | Purist K-T97328-4-BN |
| Category | Plumbing Product |
| Language | English |
Do not use the bath filler as a grab bar or support bar when entering or exiting the bath.
Keep faucet vertical and use care when installing the faucet to avoid O-ring damage.
A minimum operating pressure of 45 psi (310 kPa) is required for proper operation.
Follow local codes, turn off water, use proper drill bits, check dimensions, and review roughing-in information.
Prepare the installation site, ensuring adequate floor support is used and dimensions are correct.
Verify correct spout orientation before securing the base to the wooden support as shown.
Secure the faucet base to the prepared wooden support by drilling and tightening screws.
Apply sealant tape to supply pipes and thread them into the base, then check for leaks.
Finish the floor leaving a hole for the guard and cut the guard flush with the finished floor.
Position the faucet on the base, insert and tighten screws through the flange.
Install the handshower hose and connect it to the diverter assembly as illustrated.
Check for leaks, run water through the spout and hose, and reinstall aerator and handshower.
To Next Page
