-6-
Fig.#13
13
Carefully thread the screws into the
brackets, until toilet is secure.
Alternately tighten left and right sides
to prevent pulling the toilet off center.
Install cap to cover screw.
Do not overtighten.
Cap
Screw
Bushing
Fig.#14
14
Fig.#15
15
Apply caulk around base.
Fixing toilet seat, and turn on the angle
valve switch, it will work.
Please use the supplied hardware
pack for seat if match with C3 toilet
bidet seat. Periodically check for
several days following the installation.
C3
Fig.#12
12
Connect to water supply, ensure
nommal water supply, no any leak.
Flexible hose (not provided) are
recommended to connect the supply
line to the fill valve.
()
1535881-T2-A
To Next Page
Loading...
Need help?
General