10.
11.
Cover unable to
open/close
automatically
A.
Please sit or leave the sensing area
B. Refer to "Guide on setting of remote controller"
C. Wait until the flushing process is completed
12.
Night light does
not work
A. The night function is turned off
B. The indoor light is too bright
14.
Remote failures
A. Out of battery
B.
Battery polarities are mounted reversely
C.
The remote controller is not woken up
15.
Remote control
fails to control
the toilet
A.
B.
E
.
If necessary, turn on the water valve.
Cover fails to
close/open
A. Users are not seated yet or left the sensing area
A.
B.
C.
D.
E.
Lower battery
The remote control is too far from the toilet
The toilet is not yet powered on
The toilet itself is on standby mode
The toilet is not connected to the remote control
Replace battery by referring to the section of
"Usage and replacement of battery for remote
control"
Check the section of "Communication between
remote controller and this machine", and get
close to the toilet
C. Power on the toilet
Check the section of "Communication betwe
remote control and this machine", and
connect the toilet and the remote control
Touch the screen of the remote control
Sit near the toilet or on it
Press Wake up key on the remote control
A. Replace with new batteries
B.
Reinstall properly
C.
A. The seat is covered by foreign matters or the seat
is wet
B. The toilet cover is interfered by people at the
open/close process before
A. Remove the foreign matters or dry the seat
B. Use the remote control to open/close the toilet
cover or do it manually until it works normally.
The cover switch should not be stopped during
the open/close process
B.The function of "automatic cover-turning" of
remote controller is deactivated
C.The toilet is in the process of flushing
A. Check the section of night light at "auxiliary
keyboard function" to activate the night function
B. Please turn off the indoor light and close the
curtain
A. User does not enter or leave sensing zone.
B. The seat is covered by foreign matters or the seat
is wet
D. Press Power button at the side to wake up the
product
If this toilet is to be repaired and maintained, you have to:
Disconnect the power plug of toilet
13.
Sanitize function
is not working.
A. Close cover and reactivate Sanitize function
and close cover after unseated.
B. Remove the foreign matters or dry the seat
9.
Deodorization fan
not work
A. The seat is unable to sense human body
B. Stop button is pressed by mistake during operation
C. Auto deodorization function is deactivated
then sit on the toilet again.
C.
Refer to "Guide on setting of remote controller"
A. Adjust your sitting posture or sit on the toilet
again.
B. If necessary, please leave for about 2S and
To Next Page
Loading...
Need help?
General