1
© 2017 Kolpin Outdoors Inc. REV 02
Kit contents:
Rubber Blade Flap
Product Instructions | Part No: 10-0190
Kolpin Outdoors, Inc. | 9955 59th Ave N | Plymouth, MN 55442
(877) 956-5746 or (763) 478-5800 |
www.kolpin.com | customerservice@kolpin.com
1
2
3
4
Item Qty Part Description Spare PN
1 1 72” Rubber Blade Flap PUR1901
2 11 Hex Bolt, Zinc Plated, 1/4-20 x 0.75” LG
3 11 Flat Washer, 1/4”
4 11 Locknut, Zinc Plated, 1/4-20
CYC0967
Hardware
Package
Kolpin Blade Installation:
1. Align one end hole of the flap, item #1, with
one end hole of the blade on top edge. Use the
blade flap as a template, to drill ¼” diameter
holes into your blade where no pre-drilled
alignment holes exist. Secure the blade with
the provided ¼” x ¾” bolts, washers and lock-
nuts. Position the bolts, item #2, as shown,
from the topside down thru the flat washers,
item #3, and then secure with locknuts, item
#4, on underside of top blade edge. Tighten
locknuts to apply slight squeeze to rubber and
make sure the end of bolt is even with nut bot-
tom or bolt threads extend past the locking por-
tion of locknut.
2. Mark and the trim your excess blade flap to
proper length of your blade using tin snips or
tin shears, as shown.
Note: If any hardware is missing, do
not return to the store. Call us to
help, Toll Free 1-877-956- 5746.
To Next Page
Need help?
General
