Kolpin 93450 - User Manual

Please read and understand these instructions completely before installation to avoid injury to yourself or damage to the vehicle
or accessory.
Dealer: These instructions contain important information for future reference and must be given to the customer at time of purchase or
upon completion of installation.
Parts List:
Please Note: The Outfitter Box was designed to fit most ATV rack
systems. These particular instructions demonstrate mounting this
accessory on a tubular-type rack system. Because rack systems may
vary in size and design, use your best judgement in determining
where to locate the mounting hardware in order to provide a secure and
stable installation.
1) Position your Outfitter Box on the rear rack of your vehicle in your
desired location and center as indicated in Image “A”.
2) Once you have the Outfitter Box positioned properly, use a pencil to
mark two mounting points. Do this by scribing a line at these locations
on each side of the rack as indicated in Image “B”.
3) After you have marked the two mounting locations, remove the
Outfitter Box and carefully lay it upside-down on a level surface.
Center one of the supplied U-bolt plates on the lines you have just
marked. Using the U-bolt plate as a template, mark the two hole
locations with a pencil as indicated in Image “C”. Repeat this step.
Outfitter Box Installation Instructions
Stock No.: 93450
ITEM PART NAME PART NO.
DESCRIPTION (60-93450)
QTY.
1
Box 100-93450 Outfitter Box assembly 1
2
U-Bolt 72-0001 1/4” x 1-1/8” x 2” U-bolt, zinc-plated 2
3
U-Bolt Plate 72-0002 2” x 3/4” U-bolt plate, zinc-plated 2
4
Washer 76-0035 1/4” bonded sealing washer, zinc-plated 4
5
Washer 76-0041 1/4” lock washer, zinc-plated 4
6
Nut 77-0017 1/4”-20 finish nut, zinc plated 4
7
Thread Cap 56-0008 Black thread caps 4
Rear of
Vehicle
Image A
Center
Underside
of Outfitter
Box
Image C
Outfitter Box
Underside
of Your Rack
Image B

Summary

Parts List

Installation Guide

Position and Mark Mounting Points

Position the Outfitter Box on the rack and mark two mounting points on each side.

Prepare and Drill Holes

Use marked points to template and drill four holes in the rack for mounting.

Attach Outfitter Box

Feed U-bolts through rack and box holes, secure with washers, plates, and nuts.

Finalize Installation

Install thread caps over the U-bolts for a finished look.

Maintenance and Care

Hardware Tightening

Tighten all hardware after first use and periodically thereafter for security.

Kolpin 93450 Specifications

General

Blade Material	Steel
Blade Angle Adjustment	Yes
Material	Steel
Color	Black
Weather Resistance	Yes