KC3 PV Charge Controller Instruction Manual
1
KC3
PV CHARGE CONTROLLER
Instruction Manual
Ningbo Komaes Solar Technology Co., Ltd.
1．Characteristics
1.1 PWM to prevent power loss
1.2 Reasonable management for Batteries Charge & Discharge.
1.3 Four Working modes are optional.
1.4 LCD Display clearly indicates Working Status.
1.5 Parameters and working modes can be set up as users’ requirements under different working
conditions.
1.6 Protection for Batteries Overcharge & Overdischarge(Low volt)
Protection for Overload & Short Circuit
Protection for Reverse Polarity of solar modules
Protection for Reverse Polarity & reverse charging (during night time) of Batteries
The function of Voltage Recovery from Charging Voltage Monitor to keep Switch from vibration
1.7 6 LEDs: Charging - green, Full - green, Low volt (Overdischarge) - red,
Operate (Working) - green, Over volt - red, Over load - red
1.8 RS485 communication interface is preformed for PC connection.
1.9 Powerful TVS used for thunder-arresting
To Next Page
Need help?
General