SAFETY PRECAUTIONS FOR OPERATION
2-19
PRECAUTIONS FOR OPERATION 2
STARTING ENGINE 2
If there is a warning tag hanging from the work equipment con-
trol lever, do not start the engine or touch the levers .
CHECKS BEFORE STARTING ENGINE
Carry out the following checks before starting the engine at the beginning of the day's work.
q Remove all dirt from the surface of the window glass to ensure a good view.
q Remove all dirt from the surface of the lens of the front lamps and working lamps, and check that they light up
correctly.
q Check the coolant level, fuel level, and oil level in engine oil pan, check for clogging of the air cleaner, and
check for damage to the electric wiring.
q Adjust the operator's seat to a position where it is easy to carry out operations, and check that there is no dam-
age or wear to the seat belt or mounting clamps.
q Check that the gauges work properly, check the angle of the lights and working lamps, and check that the con-
trol levers are all at the neutral position.
q Adjust the mirror to a position which gives a good view to the rear from the operator's seat.
q Check that there are no persons or obstacles above, below, or in the area around the machine.
PRECAUTIONS WHEN STARTING
q Start and operate the machine only while seated.
q Do not attempt to start the engine by short-circuiting the engine starting circuit. Such an act may cause a seri-
ous bodily injury or fire.
q When starting the engine, sound the horn as a warning.
q Do not allow anyone apart from the operator to ride on the machine.
To Next Page
Loading...
