.
MAINTENANCE
SERVICE PROCEDURE
MAINTENANCE
SERVICE PROCEDURE
3) Lower cover (2) slowly and open it. (The right side of the
cover has a hinge.)
The strainer can be seen at portion P at the top.
4.
Remove drain plug (P2) in the strainer cover, and drain the oil
(approx. 4 liters (1.06 US gal)) collected inside the piping.
5.
Loosen mounting bolt (5) of the power train strainer, then
remove cover (6).
6. Remove spring (7), then remove strainer (8).
7.
Remove any dirt stuck to strainer (8), then wash it in clean
diesel oil or flushing oil. Wash the removed parts and the inside
of the case at the same time.
8.
Loosen mounting bolt (9) of the scavenging pump strainer,
then remove cover (10).
9. Remove strainer (11).
10.
Remove any dirt stuck to strainer (11), then wash it in clean diesel oil or flushing oil. Wash the removed parts
and the inside of the case at the same time.
11. Install the strainers in their original position.
12.
Replace the power train filter element.
For details, see "REPLACE POWER TRAIN OIL FILTER ELEMENT (PAGE 4-55)".
13. Refill the specified quantity of oil through oil filler (F).
14.
After filling with oil, check that the oil is at the specified level.
For details, see "CHECK OIL LEVEL IN POWER TRAIN
CASE, ADD OIL (PAGE 3-82)".
If the spring or strainer are damaged, replace them with a new
part.
4 - 57
To Next Page
Loading...
