.
OPERATION
OPERATION
MOVING MACHINE OFF (FORWARD, REVERSE), STOPPING
MOVING MACHINE FORWARD
WARNING
When operating the machine, always sit in the operator's seat. If you do not sit in the operator's seat, it will be impossible to
stop operations if an problem occurs and there is danger that this may lead to serious personal injury.
Do not allow any other person on the machine unless they are sitting in the assistant's seat. If they are not sitting in the
assistant's seat, there is danger that they may fall when the machine is traveling and suffer serious personal injury.
Always wear the seatbelt. There is danger that you may be thrown out of the operator's seat when the brakes are applied
suddenly and suffer serious injury.
If there is any person in the area around the machine when it is traveling, there is danger that person may be hit or caught up
by the machine and suffer serious personal injury. Before starting to travel, always do as follows.
o Before moving the machine off, check again that there is no person or obstacle in the surrounding area.
o Before starting to move the machine, sound the horn to warn the people in the surrounding area.
When traveling on snow-covered or icy roads, there is danger that the machine may slip when traveling and tip over or fall off
the road. This may lead to serious personal injury and damage. Always do as follows.
o Fit tire chains.
o Do not apply the brake suddenly on slopes. Reduce the speed and use the braking force of the engine together with the foot
brake (depress the foot brake repeatedly; do not keep it depressed) to stop the machine.
o Do not enter areas where the snow is deep. There is danger of driving off the road.
1. Check that there is no warning display on the machine monitor.
2.
Fasten the seat belt.
3.
Check that dump lever (1) is at FLOAT position and that the
dump body pilot lamp is out.
If the dump body pilot lamp is lit, operate the dump lever to
HOLD position, then operate it to FLOAT position to cancel the
dump body HOLD condition.
REMARK
When the engine is started, even if the dump control lever is at the
FLOAT position, electrically, the dump body is at the HOLD
position.
3 - 96
To Next Page
Loading...
Need help?
General
