.
OPERATION
MACHINE OPERATIONS AND CONTROLS
MACHINE OPERATION
Preparations for Moving the Machine
WARNING
Before operating the steering levers, check the direction of the track
frame.
If the sprocket is at the front, the operation of the travel levers is
reversed.
When moving the machine, check that the area around the machine is
safe, and always sound the horn before moving.
Do not allow anyone in the area around the machine.
Remove all obstacles from the travel path of the machine.
The rear of the machine is a blind spot, be extremely careful when
traveling in reverse.
If the lever is moved inside the deceleration range, engine speed will
rise suddenly. Operate the levers carefully.
For machines equipped with a travel alarm, check that the warning
equipment works properly.
1. Set swing lock switch (1) to the ON (actuated) position and
confirm that swing lock monitor lamp (2) lights up.
2.
Turn fuel control dial (3) towards the full speed position to
increase the engine speed.
3 - 108
To Next Page
Loading...
General
