974-72007001/1.0 1007D Altimeter Operators Manual
Page 26 Telemetr
Kongsberg Mesotech Ltd.
Port Coquitlam, BC - Canada
'G'm – Set Auto-Gain-Adjust Mode
This command selects the TVG adjustment method
used if auto-gain is enabled by the Set Threshold
command. m is one of:
'0' Disabled (regardless of the Set Threshold
command setting)
'1' Add or subtract a flat offset to shift the
TVG curve up or down.
The performance and stability of the Auto-Gain-
Adjustment is strongly dictated by:
Settings that affect the ping rate (e.g. Set Range
command)
Bottom Detection Method used (Set Detection
Method command)
Deployment conditions (acoustic noise, multipath,
turbulence, water column sediment, etc).
To Next Page
Loading...