What to do if compass data is missing on my Kongsberg Simrad Robertson AP300X?
If your Kongsberg Autopilot System shows missing compass data, first, if several compasses are connected, use the USER SETUP menu to select another compass. Then, check all connections. If the problem persists, the PCB or the entire unit might need replacement.
What to do if Kongsberg Autopilot System rudder response fails?
If your Kongsberg Autopilot System isn't responding to rudder commands, check all connections first. Next, inspect the Rudder Feedback transmission link and the drive unit motor/brushes. If the issue continues, the junction unit Power PCB may need to be replaced.
How to fix rudder feedback failure on Kongsberg Simrad Robertson AP300X?
If you're experiencing rudder feedback failure with your Kongsberg Autopilot System, it could be due to a missing or erratic rudder feedback signal. Start by checking all connections. If the problem persists, consider replacing the rudder feedback unit.
Why is the Kongsberg Simrad Robertson AP300X Autopilot System rudder test too slow?
A slow rudder test on your Kongsberg Autopilot System can be caused by several factors: * Excessive load on the steering gear. * Air in the hydraulic system. * Insufficient drive unit capacity. First, look for mechanical obstructions at the rudder, tiller, or quadrant and check the back drive force. Next, bleed the hydraulic system. If the issue persists, consider replacing the pump unit with a bigger one.
What to do if there is a communication failure on Kongsberg Autopilot System AP300X?
If the active control unit goes silent, which typically happens if the AP300PX is disconnected, try pressing the STBY button on the "Inactive" unit to reset it. Check and repair the Robnet cable. If this doesn't solve the problem, the Control unit or PCB may need replacement.
General| Type | Autopilot System |
|---|---|
| Manufacturer | Kongsberg Simrad Robertson |
| Model | AP300X Series |
| Power Supply | 24 VDC |
| Operating Temperature | -15°C to +55°C |
| Display | LCD |
| Rudder Feedback | Yes |
| Weather Compensation | Yes |
| Control Type | Digital |
| Communication | NMEA 0183 |
| Interface | NMEA 0183 |
| Navigation Interface | NMEA 0183 |
Details core system units like control units, junction units, and sensors.
Explains system ON/OFF, Standby mode, Follow-Up, and Non-Follow-Up steering.
Details installation procedures for Rudder Feedback, Junction Unit, and related connections.
Explains connecting drive units and mounting control units.
Guides through software setup, language, dockside, interface, and seatrial settings.
Outlines procedures for rudder zero, compass calibration, and autotuning.
Lists common alarms, probable faults, and recommended troubleshooting actions.
To Next Page
