4
Additional copy operations
4-22 bizhub 501/421/361 (Version 2)
The Check Job Settings screen appears.
5 Check the copy settings registered with the selected copy program.
– The copy settings cannot be changed from the Check Job Settings screens.
– There are four Check Job Settings screens. The number to the right of the screen title indicates the
number of the currently displayed screen.
– To display the previous screen, touch [ Back]. To display the next screen, touch [Forward ].
6 Touch [Close].
The Recall Copy Program screen appears again.
7 Again touch the button for the copy program registered with the copy settings to be recalled.
– If [OK] is touched with no copy program selected, the Basic screen appears again without a copy
program being recalled.
8 Touch [OK].
The programmed copy settings are recalled and the Basic screen appears again.
9 Press the [Start] key.
Copying begins with the recalled copy settings.
2
Note
To stop recalling a copy program, press the [Reset] key or the [Mode Memory] key or touch [Cancel].
To Next Page
Loading...
Need help?
General
