To Next PageTo Next PageWhat to do if Konica Minolta JM-103 show measurement error?
If you encounter a measurement error during average measurements or suspect a hardware malfunction with your Konica Minolta Measuring Instruments, try turning the POWER switch to OFF, waiting at least 10 seconds, and then turning it back ON. If the issue persists, it is recommended to contact an authorized Konica Minolta Sensing service facility for assistance.
Why is the measured value abnormal on Konica Minolta JM-103 Measuring Instruments?
An abnormal measured value on Konica Minolta Measuring Instruments, particularly with excessive fluctuation during average measurement, can occur if the measuring probe isn't positioned correctly. To resolve this, ensure you place the measuring probe perpendicular to the recommended point, such as the forehead or sternum, and then retake the measurement.
How to fix insufficient charging on Konica Minolta JM-103 Measuring Instruments?
To address insufficient charging on your Konica Minolta Measuring Instruments, set the POWER switch to OFF and place the instrument on the charger unit. If the issue continues, contact Konica Minolta for support.
How to fix a blank display on Konica Minolta Measuring Instruments?
If your Konica Minolta Measuring Instruments display is blank when the power switch is on, it's likely due to exhausted batteries. To resolve this, charge the battery as described in the manual.
What to do if Konica Minolta Measuring Instruments cannot take measurements?
If you cannot take measurements with your Konica Minolta Measuring Instruments, it could be due to a couple of reasons. First, make sure the Ready lamp is illuminated before attempting to take a measurement. Second, the batteries might be exhausted; in that case, charge the battery.
Why does Konica Minolta JM-103 Measuring Instruments display go blank during measurement?
If the display of your Konica Minolta Measuring Instruments suddenly goes blank during a measurement, this indicates that the batteries are likely exhausted. You should charge the battery to continue using the device.
What to do if Konica Minolta Measuring Instruments charger lamp does not illuminate?
If the charger lamp doesn't light up when you place your Konica Minolta Measuring Instruments on the charger, check these things: * Ensure that the charger unit and AC adapter are correctly plugged into a power outlet. * Make sure the Jaundice Meter is placed perpendicular to the measuring point in the charger unit.
General| Brand | Konica Minolta |
|---|---|
| Model | JM-103 |
| Category | Measuring Instruments |
| Language | English |
