SAFETY NOTES
SET UP INSTRUCTIONS
A - STAND
- The four feet 1 are extended are far as they go and placed
- on the floor.
- If needed, adjust the knurled screw 2 to level the stand in
- the case of uneven surfaces
B - ACCORDION HOLDER
The catch/clamp screw 3 consists of a common thread plus
an integrated spring loaded pin.
- First loosen the thread, then pull the screw back a bit 3a
- allowing the spring loaded pin to release the base tube.
- Extension tube 5 is placed in base tube 4
- The extension tube is positioned at the desired height: let
- the loaded pin click into the drill hole on the extension tube
- and tighten the threaded bolt 3b.
TECHNICAL DATA / SPECIFICATIONS
Thank you for choosing this product. The instructions provide directions to all of the
important setup and handling steps. We recommend you keep these instructions for
future reference.
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
17400-009-55 Rev.11 03-80-230-00 1/16
- Observe the accordion dimensions (see tech. information)
- The floor must be load bearing and even.
- Place the accordion in the stand if needed with two people.
- Ensure that the accordion weight is properly distributed and
- adjusted - tighten the screws - manual tightening is more
- than enough.
- The height of the stand is adjusted with a catch/clamp screw;
- ensure that the bolt of this screw always catches in the drill
- hole of the extension tube.
- When the accordion is in the stand - never unlatch the
- catch/clamp screw unless there is a second person there
- that can hold the instrument.
- The angle of the accordion holder is set with a locking handle.
Please tighten appropriately manual strength is enough.
- Careful and attentive handling is required when adjusting
- the stand - due to the possibility of pinching or wedging
- your hands.
17400 Accordion Stand
The accordion stand that takes the weight off of the accordionist.
- suitable for accordions of the following sizes:
- Depth: 135 - -250 mm, Height: 380-585 mm
- The stand is height adjustable from:
- 730-1135 mm (lower edge of the instrument)
- The angle of the accordion is adjustable:
- at 22° intervals forward or backward
- Easy to transport - legs are collapsible.
- Weight 7.2 kg
Material
Tubes and profiles: Steel
Handles, guides: Polyamide (PA)
Instrument supports: Rubber
End caps: (PE)
max. load
Size of the accordion:
Depth: 135-250 mm, height: 380-585 mm
Dimension
max. base circumference ø 660 mm
Height: 730-1135 mm (lower edge of the Accordion)
Box, kg W x D x H: 285 x 260 x 1000 mm, 7.2 kg
To Next Page
Loading...
Need help?
General
