SPEED DOME CAMERA
SW1
SW2
7. Down cover preliminary installation.
Attach the safety chain with a M3 nut as picture
shows.
NOTE: Plug the heater wiring into socket on
heater in the case of outdoor dome
8. Install black liner and Pan/Tilt Module. Push the
black liner into the two tabs. Install the pan/tilt
module with two clips, match color of AMP sockets.
Gently push the module upward until hearing the
click. NOTE: Remove
the lens cover
9. Install down cover
Unscrew the two M4 screw on down cover ring.
Push up the down cover into the housing and then
fasten down cover with two M4 screws.
NOTE: Apply lube to the O-ring in the case of
outdoor dome
To Next Page
