Koolbreeze Climateasy 14 - Page 15

Troubleshooting
Troubles Possible Causes Suggested Remedies
- Water full indicator lamp
blinks, and water tank is full.
Dump the water out of the water
tank.
- Room temperature is higher
than the setting temperature.
(Electric heating mode)
Reset the temperature
1. UNIT DOES NOT START
WHEN PRESSING ON/OFF
BUTTON
- Room temperature is lower
than the setting temperature.
(Cooling mode)
Reset the temperature
- The doors or windows are not
closed.
Make sure all the windows and
doors are closed.
2. Not cool enough
- There are heat sources inside Remove the heat sources if
the room.
possible
- Exhaust air hose is not
connected or blocked.
Connect or clean the exhaust
air hose.
- Temperature setting is too
high.
Reset the temperature
- Air inlet is blocked. Clean the air inlet.
3. Auto Power-Off in heating
mode
- Heating protection, when the
temperature at the air outlet
exceeds 7 0 d e g r e e s , the
unit will power off
automatically.
Restart the unit at when a lower
room temperature.
- The ground is not level or not
flat enough
Place the unit on a flat, level
ground if possible
4. Noisy
- The sound comes from the
flowing of the refrigerant inside
the air conditioner
It is normal.
5. E0 Code Room temperature sensor
failed
Replace room temperature
sensor (the unit can also work
without replacement.)
6. E2 Code 1.Very high humidity RH70%.
- It is normal: the air is too
humid: drain by hand.and
Restart the unit.
-
Note: In the event of failure, contact the retailer from whom it was purchased.
Page 14