KOOMANDO TM5886 - Technical Specifications; Working Voltage; Working Temperature; Working Time

Control panel TM5886 e TM5895
for tubular motors and dampers
User’s Manual Control Panel
TECHNICAL SPECIFICATIONS
Working Voltage: 85 - 265Vac
(110Vac 60Hz / 220VAC 50HZ)
Working temperature: -20ºC to + 60 ° C
Working time: 100s
Engine capacity: 1 HP (735W), 220Vac
or 0.5 HP, 110Vac
Integrated fuse: circuit (0.5A), motor (10A 250V)
Working frequency: 433.92MHz
Memorized remote controls max: 30
Size: 150x100x40 mm
Weight: 245 gr
IP56 protection
II. SAFETY INSTRUCTIONS
- Please read this manual before commissioning.
- Make sure the machine is not live before open the equipment
cover.
- Clear the memory before the commissioning of the unit
(ref. Erasing the memory).
- The signal can be disturbed by other communication devices.
- The unit must only be used for manual control and / or via radio
of geared motors for roller shutters.
The use for the control of high-risk systems.
- Each safety risk must be eliminated before use.
- If necessary, replace fuses with one of the same tics.
III. ELECTRICAL CONNECTIONS
I.
1
2
3
4
5
6
7
8
9
10
CAUTION
If the unit is installed outdoors, it is advisable to disconnect the at cable of the buttons.
If the motor is controlled by pushbuttons or key selector (see Diagram 1), the connection must be modied so that the motor
cables are connected to the control unit without interruption (see Diagram 2).
Diagram 1 Diagram 2
Pushbuttons or
key selector
Pushbuttons or
key selector
Control unit
Motor
Motor
10-11 output 12 Vac supply to
photocells
13-14 connection NC photocell:
if not used, leave bridged
L - N input line 220
EG ne-line-engine land
COM - ▲ - ▼ engine output
ashing light output 220V
or courtesy light
12V - GND output power photocells
N.C. photocells
◄► - COM input opening button (N.O.)
▀
- COM input stop button (N.O.)
►◄ - COM input closing button (N.O.)
- COM step by step button input
(OPEN - STOP-CLOSE- STOP ...)
Connections
+12 +12
- GND
0 V
DIP1
ON or OFF changes the
direction of movement of
the motor
DIP2
ON single button control
OFF 3 control keys
DIP3 (outputs 8-9)
ON ashing light
OFF xed light
DIP4
ON deadman
OFF semiautomatic
EN
www.koomando.com - remote control store