20
• ONLY CONNECT THE APPLIANCE TO THE POWER
OUTLETS WITH A MINIMUM CAPACITY OF 10 AM-
PERES.
• DO NOT PULL THE POWER CORD OR THE AP-
PLIANCE ITSELF TO REMOVE THE PLUG FROM
THE WALL SOCKET.
• FULLY UNWIND THE POWER CORD BEFORE
OPERATING THE APPLIANCE.
• USE AN ELECTRIC EXTENSION CORD ONLY IF
IT IS IN PERFECT CONDITION.
• NEVER LET THE POWER CORD RUN THROUGH
SHARP EDGES; AVOID CRUSHING IT.
• DO NOT LEAVE THE APPLIANCE EXPOSED TO
ATMOSPHERIC AGENTS (RAIN, FROST, SUN,
ETC.).
• NEVER USE THE APPLIANCE:
- WITH WET OR MOIST HANDS;
- IF IT HAS FALLEN AND HAS OBVIOUS RUPTU-
RES OR MALFUNCTIONS;
- IF THE PLUG OR POWER CORD DEFECTIVE;
- IN HUMID OR GAS SATURATED ENVIRONMEN-
TS.
• DO NOT COVER THE APPLIANCE WITH TOWELS,
CLOTHING, ETC.
• PLACE THE APPLIANCE ONLY ON HORIZONTAL
AND STABLE SURFACES, AWAY FROM SHOWERS,
BATHTUB, SINKS, ETC.
• IF THE APPLIANCE IS WET OF GETS IN CON-
TACT WITH WATER, DO NOT USE IT AND HAVE IT
CHECKED BY A SPECIALISED LABORATORY.
• ALWAYS REMOVE THE MAINS PLUG FROM THE
To Next Page
Loading...
