23
1 Components – Change Images
1 Control Panel 5 Water Level Window
2 Left-Right Louver 6 Remote Control
3 Up-Down Louver 7 Rear Mesh Filter
4 Castor Wheels 8 Drain Plug
Note: 2 x AAA batteries for the Remote Control are not included
2
3
4
5
6
7
8
1
• When ready to use the cooler, make sure that the power switch is
set to OFF and the unit is disconnected from the power point.
• Ensure the rubber drain plug is fully
inserted into the hole (located in the
rear of the unit at the bottom).
• Remove the top cover and pour cle-
an cold water into the water tray.
2 Preparation
Drain Plug
Water will drain
down through this
hole into the
water tank
Pour Water in
Here Only
To Next Page
Loading...
