25
Note: 2 x AAA batteries are not included.
The Cooler comes with a remote control for your convenience.
The functions on the remote control are the same as the buttons on
the evaporative cooler.
To install the batteries, first remove the back of the remote
control by sliding the back battery cover off.
Insert the batteries inside the battery compartment ma-
tching polarity icons with those in the battery compartment
and then refit the cover securely.
Battery Type: “1.5V 2 x AAA”
Do Not mix new and old batteries in the remote control.
To prevent corrosion, remove the batteries if the remote
control will not be used over a lengthy period.
• Insert the power plug into an power point and switch on. The On/
Off indictor light will illuminate.
• Press the “ON/OFF” button on the control panel (or remote con-
trol).
The unit will start in the default “Low” Speed as indicated by the
indicator light and Normal Mode, or to the pre-programmed memory
setting.
Note: Only the fan will be running at this time. To Turn Off, press the
“ON/OFF” button again.
3.1 Evaporative Cooler
3.2 Remote Control
4.1 ON/OFF
3 Controls
4 Operation
To Next Page
Loading...