Need help?Do you have a question about the Kora Explorer 150SB and is the answer not in the manual?
Lists key personnel involved in the product's development and manufacturing.
Verify mains voltage matches amplifier setting before connecting to prevent damage.
Instructions for connecting speakers and ensuring adequate ventilation for the unit.
Connect speakers to terminals (red/black, 4/8 ohm) ensuring correct polarity.
Avoid extreme conditions, chemicals, internal tampering, and retain original packaging.
Connect various audio sources (CD, tuner) to the amplifier's RCA inputs using shielded cables.
Using the Direct button for power section input and PRE OUT for preamp output signal.
Utilize the Monitor loop for recording systems, signals pass through the preamp.
Procedure for turning the unit on and off using the front POWER button and rear switch.
Integrating the 150SB into an A/V system, disassociating power and preamp sections.
Importance of matching amplifier and processor phase for optimal sound quality.
Explanation of the micro-processor protection mode and initial power-up remedy.
Detailed technical data including power, frequency band, inputs, dimensions, and weight.
Details the 2-year warranty, exclusions, and service procedures.
Description of controls and indicators on the front of the amplifier.
Description of connectors and sockets on the rear of the amplifier.
General| Type | Integrated Amplifier |
|---|---|
| Remote Control | Yes |
| Signal to Noise Ratio | >100dB |
| Outputs | Speaker terminals |
| Total Harmonic Distortion | <0.05% |
| Input Impedance | 47kΩ |
To Next Page