10
at same time, it might cause the connection does not work properly.
2.8 Wiring RS-232 Console Cable
Korenix attaches one RS-232 DB9 to RJ-45 cable in the box. Connect the DB9 connector
to the COM port of your PC, open Terminal tool and set up serial settings to 9600, N,8,1.
(Baud Rate: 9600 / Parity: None / Data Bit: 8 / Stop Bit: 1) Then you can access CLI
interface by console able.
Note: If you lost the cable, please contact with your sales or follow the pin assignment to
buy a new one. The Pin assignment spec is listed in the appendix.
To Next Page
Loading...
Need help?
General
