Korg DW-6000 - Page 10

1.
BASIC
SETUP
Before
using
the DW-6000,
fallow
these
steps.
[IIMake sure the power
switch is off.
(The
power
switch is on the left side of the
rear
panel,
as seen
from
the
rear.)
r-'
[•Ul
POWER
mPlug the
AC
cord into a
wall socket.
Attached power cord
Rear view
13]
Turn
down amplifier volume and connect the DW-6000
OUTPUT jack{s)
to
the
amplifier
or
mixer
input
jack(s).
Set
the
LOW/HIGH
switch
according to the
kind of amp
or mixer
input used.
•
ID
•
@@©
@»
7
To amp
or
mixer
Type
of
input
HFor operation without an amp
or
mixer, plug
standard
stereo
headphone into the PHONES jack
on
the
rear
panel.
Use
L/MONO for
connection to a
sin^f~~~^.
gle amp or
mixen
channel.
Switch
position
Audio amp
(AUX IN)