Korg EX-8000 Owner's Manual

TAPE INTERFACE
The EX-8000 is equipped with a tape interface that lets you SAVE all sound data stored in memory on
cassette tape. Later you can LOAD the data from the tape back into the EX-8000’s internal memory.
,A wide variety of sound data can be stored on cassette tape. The LOAD operation is so fast (a little
more than 10 seconds) that you can even change your programs during a performance.
1
Jeatures and Functions for Control-
5
TAPE TUNE
KEY ASSIGN
PROGRAMMER
PRM;RAM PARAMETER
DISABLE q q f-, fj 0 fj
Press this key to write EX-8000 program memory
contents to your connected tape recorder.
This gives you messages to keep you informed of
tape interface operations and possible problems.
Press this button to read data from your tape recorder
while playing back a tape.
This is used to check recorded data (immediately
after the SAVE or LOAD procedure) to make sure that
it has been properly performed.
If an error occurs during SAVE or LOAD operation,
pressing this key lets you start over again, if you
press the CANCEL key during SAVE, LOAD, or VER-
IFY operation, it will immediately interrupt and cancel
the operation.
This is set to ENABLE to enable LOAD operation.
This switch is set to ENABLE to make tape interface
possible.
This switch is used to make the EX-8000 match the
output level of the connected tape recorder during
VERIFY or LOAD operation.

Korg EX-8000 Specifications

General

Brand	Korg
Model	EX-8000
Category	Control Unit
Language	English