TAPE INTERFACE
q
When the DISPLAY again shows TAPE, then you can
stop the tape recorder.
This completes the SAVE procedure. However, it is
good practice to repeat the SAVE procedure several
times, as a hedge against the possibility of losing
data because of tape dropouts.
B
Reset the EX-8000 front panel TAPE switch to the
DISABLE position.
a
Do not change any settings on the EX-8000 until you
complete the VERIFY procedure (in the following
section).
TAPE
ENABLE
DISABLE
e
n
If you listen to a tape of recorded data, you will
hear the following tones:
-.I.
*
.
.
,
-a
-._
Leader tone:
Indicates the start of VERIFY and LOAD
operations.
Data tone:
The actual digital data from EX-8000 sound
program memory.
End tone:
Indicates the end of the operation.
To Next Page
Loading...
