TAPE INTERFACE
3
n
VERlFY Procedure
n
The VERIFY procedure should always be used immediately after you finish a SAVE (or LOAD) operation. This
is to make sure that data has been properly recorded. It is also useful for determining the best playback level
setting for your recorder.
q
Connect the EX-8000 front panel FROM TAPE jack to
the output jack (earphone, line out, etc.) of your
recorder. Set the High/Low switch to match your tape
recorder’s output signal level.
B
Set the EX-8000 panel TAPE switch to the ENABLE
position.
l3l
Set the tape recorder’s playback volume a bit higher
than usual. If the recorder has tone controls, set them
to the center positions.
q
Rewind the tape. Begin tape playback. Stop the tape
(using the stop or pause key) when you reach the be-
ginning of the leader tone.
q
Press the VERIFY key on the EX-8000.
The DISPLAY will show “VERIFY” to confirm the
VERIFY mode.
q
Start the tape recorder (press the play key or release
the pause key). The DISPLAY will show “VERIFY” to
confirm the VERIFY mode.
TAPE
LOW
m
HIGH
TO
FROM
Recorder output lack
HIGH/LOW
-
From recorder
This shows the EX-8000 is in the tape interface mode.
TAPE
VERIFY
The DISPLAY will
L
show the bank
number (l-8) for
the VERIFY opera-
tion.
To Next Page
Loading...
