Korg EX-8000 - Page 47

TAPE INTERFACE
q If the recorded data match the EX-8000 internal
memory data then the DISPLAY will give a “Good”
message. The DISPLAY will appear as shown here if
data is successfully verified.
0 If you get an error (Err) message as shown here
Press the CANCEL Key, lower (or raise) the tape re-
corder’s output volume, and repeat
steps&$l- lj$J
CANCEL
0 If the DISPLAY does not change after ten seconds
of tape playback
Raise the tape recorder’s output volume level and re-
peat steps m- @I.
q When you get a “Good” message, you can stop the
m
tape recorder. Make a note of the recording level,
playback level, and HIGH/LOW switch setting that re-
sulted in the “Good” message.
•I Set the EX-8000 front panel TAPE switch to the DISA-
BLE position.
TAPE
ENABLE
DISABLE
w
r ______ -__------ ------ --------------------------,
1 Note: You will not get a “Good” message if the recorded data is different in any way from the data in the
/
, EX-8000’s internal memory. If you change a single parameter value or the key assign mode and then try
1
1 VERIFY, you will get an error “Err” message.
I
(
If you still don’t get a “Good” message after trying many different output level settings on the tape
I
)
recorder (and HIGH/LOW switch settings on the EX-8000) then your recording level may be wrong. Try
saving again at a different recording level.
1
I
L ________ ------ -..--- ~~-----.-- ----- - ---- -----------_I