TAPE INTERFACE
4. LOAD
Procedurec
H This procedure is used to put recorded data back into the EX-8000’s internal memory.
q
Connect the EX-8000 front panel FROM TAPE jack to
the output jack (earphone, line out, etc.) of your re-
corder. Set the HlGHlLOWswitch to match your tape
recorder’s output signal level.
q
Set the EX-8000 front panel WRITE switch and TAPE
switch to the ENABLE
(ENA)
positions.
TAPE
ENABLE
m
DISABLE
-
The DISPLAY will now appear as shown here.
m
m
q
Set the tape recorder’s playback volume to the level
that produced a “Good” message when you use the
VERIFY procedure. If the recorder has tone controls,
set them to the center positions.
i!$
Rewind the tape. Begin tape playback. Stop the tape
(using the stop or pause key) when you reach the be-
ginning of the leader tone.
0
Press the LOAD key.
@
Start tape playback (press the play key or release the
pause key). The Display will appear as shown here.
LOAD
This shows the
bank number (1
-
8) if data is
loading.
To Next Page
Loading...
