TAPE INTERFACE
q
If the data has successfully loaded
into internal mem-
ory the DISPLAY will give a “Good” message.
I
If you get an error (Err) message as shown here
Press the CANCEL Key, lower (or raise) the tape
recorder’s output volume, and repeat
steps@-
q
.
n
If the DISPLAY does not change after ten
second&
of tape playback
Raise the tape recorder’s output volume level and re-
peat
steps@-
q
J.
181
When you get a “Good” message, you can stop the
tape recorder.
@
Set the EX-8000 front panel WRITE switch to the DIS-
ABLE position.
@Set the EX-8000 front panel TAPE switch to the DISA-
BLE position.
m
m
A “Good” message indicates the completion of loading.
m
m
ENABLE
Follow the VERIFY procedure to check if the data
from the tape has precisely loaded into the pro-
grammer or not.
TAPE
To Next Page
Loading...
