Korg K25 - Program Change Enable;Disable

20
The local control setting
Keyboard/Each controllers
Computer
K61P
KBD/KNOB
SOUND/CTRL
Tone generator
Local control on
Computer
KBD/KNOB
SOUND/CTRL
Local control off
Keyboard/Each controllers
K61P
Tone generator
The local on/off setting is set to local on if power cut off.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Program change enable/disable
Every time you select one of the K61P’s internal sounds, a MIDI program change
message is also sent to any connected MIDI equipment. This feature allows you to
prevent program change messages from being sent to your other MIDI devices.
1 Hold down [BANK] button until the K-Series enters the Setting mode.
2 Press the Program 7 [HARPSI 1/VIBE/STRINGS 1] button (the button will flash).
C8C7C6C5C4C3C2C1
3 Press note C4(enable) or C#4(disable) to select the setting.
4 Press the [BANK] button to exit the Setting mode.