Need help?Do you have a question about the Korg microSAMPLER and is the answer not in the manual?
General| Sampling Frequency | 48 kHz |
|---|---|
| A/D Conversion | 24-bit |
| D/A Conversion | 24-bit |
| Type | Sampler Keyboard |
| Keyboard | 37 keys (velocity sensitive) |
| Number of Samples | 36 per bank |
| Sequencer | 16, 000 notes |
| Display | 16 character x 2 line LCD |
| Outputs | L/Mono, R (1/4" Phone), Headphones (1/4" Stereo Phone) |
| USB | USB MIDI |
| Power Supply | AC adapter (included) |
| Inputs | Audio Input (1/4" Phone), Mic Input (1/8" Phone) |
Describes unsuitable locations and power supply requirements.
Advice on handling, cleaning, and preventing foreign matter entry.
FCC compliance information for digital devices.
Information on proper disposal of the product in the EU.
Advises on data saving and copyright compliance.
Lists the key features of the microSAMPLER.
Explains the Sampler, Effect Processor, Keyboard, and Pattern Sequencer.
Explains the RAM and ROM banks and their contents.
Details the controls and displays on the front of the unit.
Controls for pattern sequencing and sampling operations.
Audio input, display, status indicators, and operation buttons.
[EDIT] button, control knobs, and keyboard LEDs for operation.
Details all connectors and switches on the rear panel.
Illustrates typical connection methods for the unit.
Steps before powering on and battery usage details.
Steps for turning the unit on and off safely.
Loading ROM sounds and playing samples.
How to apply effects to samples.
Explains sample playback in different keyboard modes.
How to play recorded pattern sequences.
Steps to prepare for recording a sample.
Definitions of 'sample' and 'sampling source.'
How to monitor input and set tempo using Tap Tempo.
Steps to record a sample.
How to perform different sampling modes and set auto-start.
How to play samples and apply effects.
How to record a pattern and the realtime recording process.
How to undo/redo recordings and select/play patterns.
Information about banks and their settings.
How to choose sampling modes and set parameters.
MONO/ST, KEY GATE, TIME, LEVEL, FX POS, AUDIO IN.
Performing Loop, Auto Next sampling, and selecting keys.
How to sample with Key Gate and perform resampling.
How to achieve loop playback and hold samples.
Steps to edit sample parameters.
Details various sample editing parameters.
Adjusts sample stop point, decay, and release times.
SEMITONE, TUNE, LEVEL, VEL INT, PAN, FX SW.
Original BPM/Rate, Delete Sample, Swap Sample.
How to load and normalize samples.
Truncates samples and introduces pattern sequencer basics.
Explains pattern recording and methods.
LENGTH, QUANTIZE, playing patterns, and mute function.
Recording additional material and deleting pattern data.
How to swap and load patterns.
Diagrams of signal flow and realtime parameter control.
Explains delay time settings and TM RATIO.
How delay time syncs with tempo and MIDI clock.
Steps to adjust global settings and parameter overview.
PTRN CHG, KB.MIDI.CH, LOCAL, MIDI.ROUT, AUDIO IN LVL, GLOBAL.CH.
USB, MIDI, and MIDI Clock synchronization settings.
STRT.TRIM and END TRIM for noise reduction.
How to save edited data (banks, samples, patterns).
How to connect and use with external MIDI gear.
MIDI connection setup and pattern sequencer sync.
Explains MIDI channel handling and Note-on/off messages.
Details pitch bend, control change, and NRPN message usage.
Explains SysEx and realtime MIDI messages.
Details the compressor effect parameters.
Details filter effect and LFO parameter settings.
LFO sync/phase settings and 4-Band EQ parameters.
Details the distortion effect parameters.
Details the decimator effect parameters.
Details reverb and stereo delay effect parameters.
Details the L/C/R delay effect parameters.
Details the auto panning delay effect parameters.
Details the tape echo effect parameters.
Details chorus and flanger effect parameters.
Details vibrato and phaser effect parameters.
Details the stereo tremolo effect parameters.
Details the ring modulator effect parameters.
Details the grain shifter effect parameters.
Details pitch shifter and talking modulator parameters.
VO.BOTTOM, RESONANCE, DRIVE, MOD.DEPTH, RESPONSE.
Details the looper effect parameters.
Lists functions accessed via Shift and edit page shortcuts.
Comprehensive list of all parameters with page references.
Lists and explains error indications.
Lists ROM bank samples by key and name.
Lists ROM bank patterns by number.
Steps to diagnose power, sound, and MIDI response problems.
Avoiding sample noise and troubleshooting MIDI data response.
Lists technical specifications of the unit.
To Next Page
