Korg microSAMPLER User Manual

Reference guide
29
the bar below the number. Use the [VALUE/FX CONTROL 2] knob to
adjust the value.
The ones and tens place can be adjusted in two-digit groups.
END.POINT
This adjusts the point at which the sample will stop playing.
As for the start point, you can adjust this in terms of a percentage (%), a
number of beats, or a numerical value.
In some cases, the pitch may not rise above a certain level as you narrow the
interval between the start point and end point.
DECAY ................................................................................................[0...127]
This specifies the time from when the key is pressed to start playback until
when the sound disappears.
The way in which the sound decays will depend on the RELEASE setting.
If DECAY is set to a value other than “127,” the volume will continue
decreasing as the sample plays, regardless of the LOOP setting.
For example with the following settings, the sample playback volume will
change as follows.
■ With the settings DECAY = “127,” RELEASE = “0”
If DECAY is set to “127,” the volume will not decrease until you release the
key.
For example with the following settings, the sample playback volume will
change as follows.
■ With the settings DECAY = “64,” RELEASE = “0”
If DECAY is set to “126” or lower, the volume will decrease even if you con-
tinue holding the key.
RELEASE ............................................................................................ [0...127]
This specifies the time from when you release the key until when the sound
disappears.
The way in which the sound decays will depend on the DECAY setting.
When PLAY.TYPE is “LOOP OFF” (for one-shot samples)
■ With the settings DECAY = “127,” RELEASE = “127”
If RELEASE is set to “127,” the sample will play to its end without decreas-
ing in volume even if you release the key.
Length of original sample
Time
Sample
Sample
Note-offNote-on
Length of original sample
Time
Sample
Sample
Note-on
Length of original sample
Time
Sample
Sample
Note-offNote-on
Reference guide

Korg microSAMPLER Specifications

General

Sampling Frequency	48 kHz
A/D Conversion	24-bit
D/A Conversion	24-bit
Type	Sampler Keyboard
Keyboard	37 keys (velocity sensitive)
Number of Samples	36 per bank
Sequencer	16, 000 notes
Display	16 character x 2 line LCD
Outputs	L/Mono, R (1/4" Phone), Headphones (1/4" Stereo Phone)
USB	USB MIDI
Power Supply	AC adapter (included)
Inputs	Audio Input (1/4" Phone), Mic Input (1/8" Phone)