Korg microSAMPLER User Manual

Effect parameters
59
LFO SPRD (LFO Spread) ..........................................................[–180...+180º]
Specifies the LFO phase difference between the left and right channels.
17. RING MOD (Stereo Ring Modulator)
This effect produces a metallic tone by multiplying the input signal with an
oscillator. By modulating the oscillator with an LFO you can produce
extremely drastic modulation. By making the oscillator frequency follow the
note number, you can produce ring modulation effects that have correct
pitches.
DRY/WET .............................................................. [DRY, 99:1...1:99, WET]
Adjusts the balance between the effect sound and the direct sound.
OSC MODE ...............................................................................[FIXED, NOTE]
Specifies whether the oscillator frequency will follow the note number.
With the NOTE setting, the oscillator frequency will follow the note number
of the input signal.
FIXD.FREQ (Fixed Frequency) .....................................[0 Hz...12.00 kHz]
Specifies the oscillator frequency when OSC MODE is set to “FIXED.”
If this parameter is assigned to a knob, the assignment will change to
NOTE.OFST if you change OSC MODE to “NOTE.”
NOTE.OFST (Note Offset) ....................................................... [–48...+48]
Adjusts the pitch difference in semitones relative to the input note when
OSC MODE is set to “NOTE.”
NOTE.FINE ................................................................................[–100...+100]
Adjusts the pitch difference in cents relative to the input note when OSC
MODE is set to “NOTE.”
By using NOTE.OFST and NOTE.FINE to make the oscillator frequency track
the input note, you can obtain a ring modulation effect that preserves the
correct scale.
OSC WAVE (OSC Waveform) ....................................[SAW, TRIANGLE, SINE]
Selects the oscillator waveform.
LFO INT (LFO Intensity) ........................................................... [–63...+63]
Adjusts the depth of modulation produced by the LFO.
LFO SYNC (LFO Tempo Sync) ......................................................... [OFF, ON]
☞p.48 “LFO SYNC (LFO Tempo Sync)”
LFO FREQ (LFO Frequency) .........................................[0.01...100.00 Hz]
☞p.48 “LFO FREQ (LFO Frequency)”
SYNC.NOTE (LFO Sync Note) ..................................................[8/1...1/64]
☞p.48 “SYNC.NOTE (LFO Sync Note)”
LFO WAVE (LFO Waveform) ............[SAW, SQUARE, TRIANGLE, SINE, S&H]
☞p.48 “LFO WAVE (LFO Waveform)”
LFO.SHAPE ................................................................................... [–63...+63]
Adjusts the LFO waveform.
KEY SYNC (LFO Key Sync) .............................................................. [OFF, ON]
☞p.49 “KEY SYNC (LFO Key Sync)”
INI.PHASE (LFO Init Phase) ............................................................. [0...180º]
☞p.49 “INI.PHASE (LFO Init Phase)”
PRE LPF ............................................................................................. [0...127]
Specifies the amount of high-frequency attenuation applied to the sound
that is input to the ring modulator. The effect sound will tend to be muddy if
the input signal contains numerous overtones, so you may wish to use this
parameter to cut the high frequency range.
Dry / Wet
Dry / Wet
Pre LPF
Ring Modulator
Pre LPF
Ring Modulator
Note No.
OSC Mode
Fixed
Note (Key Follow)
Fixed Frequency
Pitch
Note Offset, Fine
Oscillator
LFO
Left
Right
Wet: Stereo In - Stereo Out
Effect parameters

Korg microSAMPLER Specifications

General

Sampling Frequency	48 kHz
A/D Conversion	24-bit
D/A Conversion	24-bit
Type	Sampler Keyboard
Keyboard	37 keys (velocity sensitive)
Number of Samples	36 per bank
Sequencer	16, 000 notes
Display	16 character x 2 line LCD
Outputs	L/Mono, R (1/4" Phone), Headphones (1/4" Stereo Phone)
USB	USB MIDI
Power Supply	AC adapter (included)
Inputs	Audio Input (1/4" Phone), Mic Input (1/8" Phone)