Korg Nu:Tekt NTS-1 digital kit - Checking After Assembly; Troubleshooting

87
En
Checking after assembly
Afterassemblingthekitandbeforeturningonthepower,makesure
tocheckthefollowing.
•
Arethepartsmountedinthecorrectdirection?
•
Isthekitbuiltsecurely,withoutwobbling?
Troubleshooting
Extra parts remaining, or parts missing.
Therearemorescrewsthanthenumberthatwillbeused.
Ifanypartsaremissing,contactyourlocalKorgdistributor.
Ifanypartsaredamagedormissingbeforebeginningtheassem-
blyprocedure,contactyourlocalKorgdistributor.
The unit makes an abnormal sound when tilted or shaken
after assembly.
Aloosescreworotherpartmighthavebeenleftinsidetheunit.
Opentheunitandchecktheinside.
The device does not turn on.
Instep4(1),thepinpositionsmaybemisalignedwheninserting
thecircuitboard.Makesurethatthepinsareintheproperposition
wheninserting.
Instep3(3),theatcablemaynotbeinsertedcorrectlyintothe
connector.Makesurethattheatcableisinsertedintotheconnec-
tor.
4
ⒶⒺ
Makesurethatthecircuitboardsfor(1)arenot
misalignedwheninserting.
The section on
Ⓑ
with holes indicated by an
arrow is the rear side.



。
5
ⒸⒹ
6
Refertothefollowingwhenattachingacustomsideboard.
SC1
SC1
SC1
SC1
(1)
(2)
SC1
:
4
SC2
SC2
SC2
SC2
SC2
: 8
e
e
52mm
Ø 2.4mm