g
To ensure long life for the Poly-800, the following
precautions should be
taken
LOCATION:
Do avoid malfunction, do not use or leave the
Poly-800
in the
locations for long periods of time:
In
direct sunlight.
In extremely high or low temperature or humidity.
In
dusty
or
sandy places.
MUSICAL INSTRUMENT
-
HANDLE WITH
CARE!
*
The
Poly-800
may malfunction if excessive force is applied
to the switches and/or knobs or if it is dropped.
CLEANING:
l Use only a soft dry cloth to clean the surface of the
Poly-800.
NEVER use benzene. thinners or similar solvents.
INTERFERENCE FROM OTHER ELECTRICAL
APPLIANCES
The
Poly-800
uses advanced digital circuitry which may oc-
casionally malfunction due to interference produced by
fluorescsent
lamps, other digital equipment, or electrical ap-
pliances with built-in motors. We recommend that you use the
Poly-800
as far as possible from such appliances. If any ir-
regularities occur, turn the power switch off. wait about 30
seconds, then turn the power on again. This should help
return the
Poly-800
to its normal operating condition.
MEMORY BACKUP
l
A
built-in battery powered circuit protects
,the
memorized
sound programs when the power is
turned off. If
the
Poly
800 is
left
without a battery for more than five minutes.
or
if the batteiy becomes exhausted. the
contents
of the
pro-
gram memory may be erased. Therefore, the batteries
should be checked
reasonably
often and replaced when
necessary.
Even if you use the
Poly-800’s
AC adaptor when play-
ing, always keep
good
batteries in the unit to avoid
memory
loss.
Be sure to change the batteries quickly to avoid possible
loss
of
program memory.
The
Poly-800’s
TAPE INTERFACE SYSTEM is an excellent
safeguard against loss of memory. In addition to providing
access to virtually unlimited programs. you may easily
re-
load memory (should it become erased) using the Tape In-
terface
system
and the supplied Program Data Tape. If’s
always a good idea to Save any original programs on tape
to protect them against
accidental
loss.
WARRANTEE
The
Poly-80O
is warranted by the
manufacturer
against
defects
in materials or workmanship. The specific conditions and
terms of the warrantee are listed on the enclosed warrantee
registration card.
INSTRUCTIONS
To obtain the best possible results from
your
Poly-800.
please
read this manual carefully. Keep
your
Owner’s Manual in a
safe place for future reference.
I
“NOTICE”
.
Because the
PO/y-800’s
case is con&ted of
a
light weight, high impact
PlBS”
material, it’s possible for elec-
trostatic discharges to occur which may cause
a
temporary malfunction. Connecting the unit to an amplifier mixer
etc. (to provide
a
proper ground connection) BEFORE turning the power on
will
help
ensure
reliable
operation.
To Next Page
Loading...
Need help?
General
