When setting up the
Poly-800.
please follow the procedure
below.
1. Make sure that everything is properly connected
as
described in Basic Connections. with all power turned
OFF.
2.
Set the Program and Sequencer WRITE switches and
the TAPE switch (on the rear panel) to the DISABLE
position.
--
3.
Turn on the power Switch. (If you are using an amplifier,
turn the amp Volume all the way down BEFORE turning
on the power.) The front panel LED Display will display
the following message:
PITOGRAH
HO.
PNw.ME
A
NO.
VALUE
This dot lights up in
DOUBLE
MODE (4 Voices)
4.
If you are using an amplifier, first set the amplifier Volume
to a suitable position, and then adjust the
Poly-800
VOLUME control for the desired level. If the sound
becomes harsh or distorted. turn down the
Poly-800
VOLUME and/or the amp Volume.
2.
SELECTING
PROGRAMS
Any of
the
64
different sounds programmed
into
the
Poly8O0’s
memorv
mav
be instantly selected. Each program location is
identified
by a two
digit.“Program
Number, which is used
whenever a program is stored, recalled or moved
from
one
location (Program Number) to another.
(2) Selecting Programs
When the Power switch is turned on. the LED Display
shows the following:
(1)
Program Numbers
A program number is a two digit number ranging from
It
to 88 (the digits 0 and
9
are not used). The first digit
indicates the Program “Bank’: and the second number
indicates the individual program WITHIN that
Program
Bank. For example, Program Number
36 would be
program
#6
in bank 3. The 64 program locations are
arranged in 6 banks or groups of
8
programs each:
Program numbers
Number
of
programs
total
The eight number buttons
are
used
both
to SELECT PRO-
1
GRAMS and
10
SELECTPARAMETERS within
a
program
11-18
I
8
When the
Poly-800
is turned on, Program
Select
made is
automatically chosen (only
three
characters shown in
the
Disp1ay).
The PROG/PARA button
is
used
to
switch
bet-
ween
the two modes.
21-28
8
31-38
8
.
41-48
8
64
51-58
8
The display indicates Program Number
“:
:
”
and the
“POLY”
mode, the normal playing mode, have been
selected.
NOTE:
61-68
8
IF
ALL 6 DIGITS ARE DISPLAYED, YOU ARE IN
PARA-
71-78
8
METER MODE AND SHOULD PRESSTHE”PROG/
PARA”
81-88
8
BUTTON BEFORE SELECTING A NEW PROGRAM.
_~_~____
__..
,__
.~
-..
_..
-._
To Next Page
Loading...
Need help?
General
