Various messages
161
Error in reading from medium
Error in writing to medium
F
File already exists
File is read only protected
File unavailable
File/path not found
I
Illegal file description
Illegal SMF data
Illegal SMF division
Illegal SMF format
M
Measure over max
Measure size over
Measure size over max
Medium changed
Situation:
Reading from a floppy disk was unsuccessful.
Action:
Try the reading operation once again. If the same error occurs again, it is possible that
the data on the disk has been damaged.
Situation:
Writing to a floppy disk was unsuccessful.
Action:
It is possible that the floppy disk is physically damaged. Use a different disk. Avoid
using the floppy disk that produced the error.
Situation:
When attempting to execute Create Directory or Rename File, a directory or file of the
same name already exists on disk.
Action:
Either delete the existing directory or file, or specify a different name.
Situation:
You attempted to save a file with the same name as a read-only file already existing on
the floppy disk.
Action:
Save the file under a different name.
Situation:
You attempted to load or open a .PCG, .SNG, or .EXL file whose file format was incor-
rect.
Situation:
The specified file or directory does not exist. Or, you attempted to open a DOS direc-
tory that exceeds the hierarchy limit (64 characters or less for the full pathname).
Action:
Check the file or directory.
Situation:
An invalid filename was specified as the name for saving a file or creating a directory.
Action:
Specify a valid filename. Filenames which cannot be recognized by MS-DOS cannot be
used.
Situation:
You attempted to load a file which was not a Standard MIDI File.
Situation:
You attempted to load a timecode based Standard MIDI File.
Situation:
You attempted to load a Standard MIDI File whose format was neither 0 nor 1.
Situation:
If the editing operation were executed, the track length would exceed 999 measures.
Action:
Delete unneeded measures.
Situation:
When loading a Standard MIDI File, the number of events in a single measure
exceeded the maximum (approximately 10,000 events).
Situation:
If the editing operation were executed, the maximum amount of data that can be
included in a single measure would be exceeded.
Action:
Use Event Edit etc. to delete unneeded data.
Situation:
The floppy disk was exchanged.
To Next Page
