Triton Studio 61/76/88 Test Mode
How to start the test mode:
[ENTER] + [5] & [POWER ON]: Full test
[ENTER] + [2} & [POWER ON]: Test for repair (Internal test skipped)
[ENTER] + [.] & [POWER ON]: Backup ROM test skipped
[ENTER] + [-] & [POWER ON]: Copying the factory data to HDD
[ENTER] + [3] & [POWER ON]: EXSB-MOSS test
[ENTER] + [4] & [POWER ON]: SIMM full test
[ENTER] + [7] & [POWER ON]: EXB-DI test
[ENTER] + [9] & [POWER ON]: Indication of the software version
[ENTER] + [0] & [POWER ON]: Flash Memory initialization
How to operate the test mode:
[ ] Item Down
[ ]Item Up
[<<REW]: Step Down
[FF>>]: Step Up
[ENTER]: Proceeding the check
NOTE:
Once the test mode starts, the calibration values of Touch panel, Ribbon Controller,
Joystick, Pedal, Aftertouch are cleared. Please execute checks of these items.
NOTE 2:
You will see a "Memory Verify Error" if the consumer has made any changes to the contents
of the hard drive. Therefore, this error message is not necessarily an indication of a defect.
To Next Page
Loading...
