volca drum System Firmware Update Instructions
3. Connect the audio output of your playback device to the SYNC IN connector on your volca drum.
Perform the update
1. Turn the power on while pressing the FUNC and REC buttons.
“SYS uPdt” will be displayed on the LCD screen to indicate that volca drum is in update mode.
2. Start the playback of volca_drum_sys_0114.wav to begin updating.
Make sure the volume of the playback device has been turned up.
STEP LEDs 1-8 will indicate the update the transfer progress, LEDs 9-16 indicate the FLASH
programming and verification progress.
Make sure the update file is played from the beginning.
When using a computer, any other system sounds (e.g. email notification) will cause the update
to fail. Make sure all other applications are shut down and do not operate you computer during
the update.
To Next Page
Loading...
