Why are the readings climbing or falling over time on my Koslow Test Equipment?
If your Koslow Test Equipment gives readings that climb or fall over time, it's because the hot probe should only touch the test metal briefly, for one or two seconds. Apply light pressure (about 70 psi) when pressing the hot tip to the metal, and wait 5 seconds between tests.
What to do if I cannot get a 60 (±5) reading with the standard Alloy C-276 on my Koslow Test Equipment?
If you cannot get a 60 (±5) reading with the standard Alloy C-276 on your Koslow Test Equipment, it may be due to several factors: * Ensure the probe tip is tightly installed using pliers. * Clean the metal tips and parts. * Avoid working near fans, vents, or air movement. * Keep away from large machines that could cause electromagnetic interference. These steps should help stabilize the TEAS readings.
What to do if the display reads 0000 even when making contact with test metal on my Koslow Test Equipment?
If your Koslow Test Equipment display reads 0000 even when making contact with the test metal, it indicates an open circuit or no reading. Ensure the test metal is free of paint, grease, and other non-conductive coatings. Also, check the Cold Contacts.
Why is the reading changing from passive to non-passive when testing the same area multiple times with my Koslow Test Equipment?
If you are testing the same area multiple times with your Koslow Test Equipment and the reading changes from passive to non-passive, it is because multiple tests should not be performed in the exact same spot. Allow the area to cool to ambient temperature before testing a second time.
How to test very small parts and wire with Koslow Test Equipment?
To test very small parts and wires with your Koslow Test Equipment, it is necessary to contact the wire at two points. Place small parts like fasteners or wire on a clean conductive block for testing.
Why does the tip of my Koslow Test Equipment appear discolored?
If the tip of your Koslow Test Equipment appears discolored, it is due to temperature changes affecting the hot tip, which may change from its normal copper color. To resolve this, gently wipe the tip with a gentle abrasive.
How to test all areas of a tank with Koslow Test Equipment?
An accessory is available for Koslow Test Equipment to address this issue. The extension handle (Part No. TE -KFG) is up to 4 feet long.
What to do if the number 1 is on the display and does not change on my Koslow Test Equipment?
If the number 1 is on the display of your Koslow Test Equipment and does not change, it indicates damage to internal components. Contact Koslow for calibration and repair.
How to reassemble unscrewed and opened probe of Koslow Test Equipment?
The probe of Koslow Test Equipment should only be serviced by Koslow service technicians. Do not open the probe screws.
General| Brand | koslow |
|---|---|
| Model | TE-3000-HD |
| Category | Test Equipment |
| Language | English |
To Next Page