Need help?Do you have a question about the Kospel PPE2 and is the answer not in the manual?
General| Brand | Kospel |
|---|---|
| Model | PPE2 |
| Category | Water Heater |
| Language | English |
Mains connection and fire protection by qualified persons, use of RCDs (30 mA).
Avoid explosion hazards, sub-zero temperatures, and store properly to prevent damage.
Do not remove the cover with power on; failure to install filter can cause damage.
Descale periodically; hot water over 50°C poses burn risk, especially to children.
Set heater power and type using switches before initial start-up.
Adjust temperature using knob; cycle through memory settings (ECO, SINK, BATH) and save.
Access service functions, restore factory settings, or restart controllers before exiting.
Display shows 'STOP' or error messages for faults like sensor failure or air bubbles.
Number of impulses on green indicator signals faults like max temp, sensor failure, or master appliance switch-off.
Steps for cleaning the filter: disconnect power/water, remove, clean, and reassemble.
Rated voltage, current, and connecting wire sizes for KDE models.
Specifications for KDE.4 models including voltage, current, efficiency, and wire sizes.
Rated voltage, current, and connecting wire sizes across various models and power ratings.
To Next Page
