Need help?Do you have a question about the Kospel KDE2 and is the answer not in the manual?
General| Installation Type | Wall-mounted |
|---|---|
| Minimum Water Pressure | 0.1 MPa |
| Protection Degree | IP25 |
| Heating element | Copper |
| Thermostat | Yes |
| Overheat protection | Yes |
| Type | Electric instantaneous water heater |
| Heating Time | N/A (Instantaneous) |
| Minimum Wire Gauge | 4 mm² |
| Water Connection | 1/2 inch |
| Protection class | Class I |
| Voltage | 400V 3~ |
Electrical connections and fire protection checks must be performed by a qualified person.
Ensure proper grounding and install a residual current circuit breaker (max 30 mA).
Set heater power and configuration switches before initial start-up. Factory settings for KDE are recommended.
Adjust temperature using the knob. Save new values within 10 seconds.
Adjust setpoint and other parameters by pushing and turning the knob. Confirm changes within 10 seconds.
Set desired temperature by pressing icons. Save new values within 10 seconds.
Detailed technical data for KDE models including voltage, current, efficiency, dimensions, and weight.
Technical data for KDE.4 models including voltage, current, efficiency, and dimensions.
Technical data for PPE2, PPVE, KDE2 models including power, voltage, current, and dimensions.
To Next Page
